Mold behind a wall in South Florida most often follows a leak from plumbing, a window or slider, or the roof line. Finding that source matters as much as removing the growth. Call the number on this page to be connected with a local mold company in Lantana.

Clues and what they can mean
| What you see | What it can mean |
|---|---|
| Bubbling paint | Moisture pushing out from the drywall |
| Swollen baseboard | Water wicking up from the bottom plate |
| Musty odor, no stain | Dampness in the cavity |
| Warm, damp tile wall | A leak behind the tile backer |
A company can sort out which of these applies by taking readings before anything is cut open.
Plumbing inside the wall
Supply lines, drain lines, shower valves and ice maker lines all run through wall cavities. A pinhole or loose fitting can drip for a long time before it stains anything. Drywall wicks that water upward, and mold can start on the back of the board while the front still looks dry and clean.
Oceanfront and waterway homes face constant moisture in the air, which slows drying and lets a small wall leak linger far longer than it would farther inland.

Cost drivers at a glance
| Factor | Effect on the job |
|---|---|
| Wall area affected | More removal and drying |
| Finish type | Tile and cabinets take longer |
| Containment needed | Adds setup work |
| Source still leaking | Plumber or roofer first |
A company can walk the wall with you and explain which of these apply, and which are likely to change once it is opened.
Removal, drying and the rebuild
Affected drywall and insulation are cut out and bagged, framing is cleaned or treated as needed, and fans or dehumidifiers dry the cavity. Many companies stop there and leave the closing and painting to a general contractor, so confirm who handles the rebuild before you sign.
Keeping humidity in check
EPA recommends keeping indoor humidity below about 60 percent, and ideally between 30 and 50. In a South Florida home that means running the AC regularly, using bathroom exhaust fans and not letting a closed-up house sit in the heat. Drier air makes a wall cavity far less welcoming.
Before work starts in Lantana
Florida requires mold assessors and mold remediators to hold a state license through the Department of Business and Professional Regulation (DBPR). Ask for the license number and look it up before anyone starts.
Under Florida's 12-month rule, the company that tests or assesses a home generally can't be the one hired to remediate it, which keeps the scope honest.
the Lantana Building Department handles building permits here, so that's the place to check before walls, cabinets or flooring go back in.
To see whether a property sits in a mapped flood zone, start with Palm Beach County Planning, Zoning & Building.
Companies that take calls here usually also work in Lake Worth Beach, Hypoluxo and Atlantis.
Mold in Walls questions in Lantana
How can I tell if there is mold inside my wall?
What is an inspection opening?
Is bleach a good way to treat wall mold?
Does a business that finds mold also have to hold a license?
More mold services in Lantana
Mold in Walls nearby
Helpful guides
Sources
Last updated: