Published price guides put a typical West Palm Beach mold job at roughly $11 to $22 per square foot, and a single room in South Florida at $1,500 to $6,000. Those are ranges from third-party cost guides, not quotes, and your own number depends on what is wet, what is behind it and how far it has spread.
Quick cost estimator
Typical ranges from the sources cited below, not a quote. The company you hire will price the actual job.
The short version
One West Palm Beach cost guide lists mold remediation at about $11 to $22 per square foot, which works out to $1,100 to $2,200 for a 100 square foot job. A South Florida price guide puts a single-room job at $1,500 to $6,000. Both are published estimates from companies that sell these services, so treat them as a way to sanity-check a quote rather than a price list. The calculator above lists every sourced range in one place.
If you want to talk through your situation, the number on this page connects you with an independent local mold company. We are a referral service, not a mold company, and we do not set prices. Each company quotes its own work.
What the sourced ranges cover
| Job | Range | Area of the source |
|---|---|---|
| Typical home mold remediation | $11 to $22 per sq ft | West Palm Beach |
| Single-room remediation | $1,500 to $6,000 | South Florida |
| Mold inspection (independent assessment) | $450 to $900 | South Florida |
| Lab air sample | $50 to $120 per sample | South Florida |
| Attic mold removal | $1,000 to $7,000 | South Florida |
| AC and duct mold cleaning | $3,000 to $10,000 | South Florida |
| Black mold removal | $2,000 to $10,000 | National, no Florida figure found |
| Post-remediation clearance test | $300 to $500 | South Florida |
Notice the spread. Even the single-room range runs a fourfold gap from bottom to top. That gap is the honest answer to "how much will mine cost": nobody can say until someone looks at the job.
Why two homes with the same square footage can price very differently
Square footage describes the visible surface, not the work. Several things change the scope.
- Source of moisture. Mold that comes back is usually a moisture problem that was never fixed. EPA states that the key to mold control is moisture control, so a company that only cleans the surface and ignores a leaking roof, a clogged AC drain or a weeping pipe is selling you a repeat visit.
- What the mold is growing on. Mold on hard surfaces like block and tile can often be cleaned. Mold in drywall, insulation or carpet padding generally means removing and replacing the material, which adds demolition and rebuild cost.
- Containment and air control. Sealing off the work area and running filtered air machines adds labor and equipment. Larger or spreading jobs need more of it.
- Location in the house. Attics and the closets or garages where air handlers sit are tight, hot and awkward to work in. The South Florida price guide puts attic jobs and AC or duct jobs in their own, wider ranges for that reason.
- Rebuild work. Remediation removes the mold. Replacing drywall, paint, flooring and trim is often a separate contractor and a separate price.
Inspection and testing are separate line items
Many owners expect one price. In practice, there is often an assessment, a remediation and a clearance step, and Florida law keeps some of those apart. Under s. 468.8419, Florida Statutes, a mold assessor cannot perform or offer to perform remediation on a structure that the assessor or the assessor's company assessed within the previous 12 months, and a remediator cannot assess a structure it remediated in that window. In plain terms, the company that writes the scope of work is generally not the one that does the cleanup. That separation protects you, because the person deciding what needs to be done has no stake in selling you more of it. Our Florida mold license rules guide explains it in full.
The same South Florida guide lists an inspection at $450 to $900 and a post-remediation clearance verification at $300 to $500. Lab samples are quoted separately at $50 to $120 each. Our guide on inspection versus testing covers when sampling makes sense at all. Both the CDC and the Florida Department of Health say they do not recommend routine mold testing, and the Florida Department of Health says sampling is not needed when mold is visible.
When insurance may help with the bill
Coverage varies a lot by policy and by cause. The Florida Department of Financial Services says a property mold endorsement lets you raise the mold damage limit to $25,000 or $50,000, and that your insurer may offer other limits. The page does not state a default limit, so check your declarations page or ask your agent before you assume anything. Flood damage is a separate matter: Palm Beach County's flood information page states that home insurance does not cover floods. If the mold followed storm water coming in from outside, read our guide on mold after a hurricane or flood and talk to your insurer early.
How to compare quotes without getting burned
- Ask each company to state its state mold license number, then look it up yourself on DBPR's search. Holding a state mold license is a statutory requirement for mold remediators in Florida, and DBPR lists the records by name or license number.
- Get the scope in writing: which rooms, which materials come out, what containment is used, and whether rebuild is included.
- Ask what happens to the moisture source. A quote with no mention of the leak or the humidity is incomplete.
- Ask how completion is verified. A clearance test by an independent assessor is separate from the company's own walk-through.
- Be wary of any price over the phone for a job nobody has seen. A range is fine. A fixed number with no inspection is a guess.
Permits can also matter. The City of West Palm Beach Building Division states that structural, electrical, mechanical, plumbing and gas work needs a permit regardless of cost, so if rebuilding after remediation touches those systems, ask who pulls the permit.
Smaller jobs you may be able to handle yourself
EPA says that if the moldy area is less than about 10 square feet, in most cases you can handle the cleanup yourself. Larger areas, or anything involving a lot of water damage, call for more extensive guidance. Even for a small patch, fix the source first. Our guide on DIY cleanup versus hiring a pro walks through where that line sits.
Services and next steps
Pricing differs by service, so start with the one that fits your problem: mold removal and remediation, mold inspection or AC and duct mold removal. If you are outside the city, check the towns we cover across Palm Beach, Martin and Broward counties, or browse all mold services.
Why South Florida costs behave the way they do
Local conditions shape the bill. Air conditioning runs most of the year, and air handlers sit in closets, garages and attics where a clogged condensate line can drip for weeks before anyone notices. Concrete block and stucco homes on slab do not have basements, but they do have roof leaks, window-frame leaks and summer storm water that gets pushed sideways into walls. In low coastal areas and along canals, storm surge and flooding add another layer. Each of these leads to a different kind of job: a duct cleaning and drain repair, a wall opening and drywall replacement, or a full flood response. That is why the sourced ranges are so wide, and why the AC and duct range tops out far higher than a single room.
Condos add their own wrinkle. In a unit, the source of the water may be a neighbor's pipe or a building riser, so who pays and who repairs can be a separate conversation. Our guide on mold in a condo or rental covers that question.
A worked example, using only sourced numbers
Suppose a ceiling stain in a West Palm Beach home turns out to be a slow roof leak, with growth on about 100 square feet of drywall. Using the West Palm Beach guide's $11 to $22 per square foot, the remediation lands at $1,100 to $2,200. Add an independent inspection at $450 to $900 and a clearance verification at $300 to $500, both from the South Florida guide. The combined range is about $1,850 to $3,600 before any roof repair or drywall rebuild, which are priced by other trades. If the mold turned out to be spread across an entire room instead, the single-room range of $1,500 to $6,000 is the better yardstick.
Your own job will not match this example, and it should not be read as a quote. The point is to show how the pieces add up, so you can ask better questions when a company gives you a total.
If you have health concerns, talk with your doctor.
Frequently asked questions
How much does mold removal cost per square foot in West Palm Beach?
Does homeowners insurance pay for mold removal in Florida?
Is the inspection included in the removal price?
Why is my quote so far from the published ranges?
Sources
- Mold Remediation Cost in West Palm Beach, Florida (HomeBlue)
- Mold Remediation Cost in South Florida (Advanta Clean price guide)
- How much does mold remediation cost? (HomeGuide, national)
- Florida DBPR: Mold-Related Services FAQs
- Florida Statutes s. 468.8419: Prohibitions; penalties
- Florida Department of Financial Services: Homeowners policy endorsements
- EPA: A Brief Guide to Mold, Moisture and Your Home
- Florida Department of Health: Mold
- City of West Palm Beach Building Division
Last updated: